Flashing Cell Phone | Flashing Phone | Mobile Phone Repair
Flashing Phone
Click UFS_DCTxBB5 icon
Click connect
Clicking WD2 then choose type of hand phone that will be flashed.
Clicking MCU, Choosing file that contain C1 in the end.
Click PPM, choosing file that contain 32 in the end.
Select UI Factory
Click flash for running process
For WD2's type after process flashing finished, click format of user area chooses YES.
Antenna
Battery Connector
Screw
Service Book
Buzzer
Camera
Charging Connector
Data Cable
Flexcable
IC
Navigator
LCD
Membrane
Mic
Midle Plate
Simcard Connector
Speaker
Switch on-off
Blower
Service Tools
Vibrator
Flasher
ARTIKEL & TIPS
Tips buying second-hand mobile phone
mobile phone with as same as flash cable
The same of UEM code
Jumper of Antenna
Spare Parts Troubleshooting
No Signal/No Network
Contact Service
Tips for Mute mobile phone
No Charging
Keypad
Wasful Battery
Signal turn up and then pass away
Failed calling
Upgrade for Firmware
Fall mobile phone
mobile phone die when used calling
MMC corrupted
Jumper connector of LCD N 3100
Interface of UFS-8
Net Monitor
mobile phone's Lamp died
SIM CARD
Repair nokia 6600 using ufs-8
mobile phone died caused of water
Mobile phone can't vibrate
Mobile phone died after flashing
Power Suply
Mobile phone often died by its self
Mobile phone died caused of software
The signal lost when calling
Mobile phone caused if IC CPU
Detect error using UFS 8
Choosing File Flash
Handphone can't flame
Repair Sony Ericson using UFS 8
