Sometimes, when analyzing failure of hand phone, A technician must check connection between hand phone with UFS-8 Box and USB cable to computer or Laptop. if wrong analyze will have fatal consequences. when seen connection between hand phone to cable then to UFS-8 then from UFS-8 to computer are good condition. it isn't sure that all can connected well.
What must we do to certain that connection from hand phone, Cable, UFS-8 and Computer on good condition? So that you can easily analyze damage hand phone. First choose appropriate handphone series that is DCT3, DCT4, DCTL, WD2 or BB5. After it connect it by press button “Connect” and UFS-8's software report showed message "License True" in monitor computer, it's Meaning computer has known UFS-8.
And then use menu "Check" and "Info" in UFS-8 software. Press button “Check” and Seeing the result. when it repeat until two or 3 times all “Boot Ok” although hand phone or UFS-8 boxnya was shift and wasn't changed. but if hand phone or UFS-8 box shift then result “Boot Error" means that you must check all connections especially connections from hand phone to UFS-8s. Ascertain that terkoneksi between hand phone with cable. check all pin what still functioned well cable or There are pin sloping cable or Crooked. Dont crudely or Depressing it considerably hard so that doesn't notch pin cable or Even component other in handphone PCB which near cable hand phone.
When press button “Check” in UFS-8's software, Report always "Boot Ok". Next step are seing what hand phone can give info with press tonbol “Info”. Info that seen MCU, PPM, IMEI and another hadware data of hand phone can be seen in monitor. With data hand phone, you can detect and analyzing that software error or hardware.
